backup setup

User Help, discussion of features, issues, and general topics about Uranium Backup.

Moderators: Davide Costantini, Romana Romandini, Andrea Ciotti, Administrator

Posts: 1
Joined: Tue May 16, 2017 1:04 pm

backup setup

Postby mentes mehmet » Tue May 16, 2017 1:12 pm

Hi all new to this Forum, I am on a new client job and not used Uranium backup before , but when trying to setup a backup job get "the client cannot connect to the destination specified in the request" i have run the winrm quickconfig, but says all ok looked at the services and all seem to be tuning? wondered if anyone could point me in the right direction.

User avatar
Posts: 144
Joined: Wed May 04, 2016 9:30 am

Re: backup setup

Postby cinzia.mancini » Fri May 19, 2017 2:13 pm

Hi mehmet,
I dont' understand very well: when so you see the message?
Can you send me a screen shot please?
Thank you
Cinzia Mancini
Nanosystems S.r.l.
Assistenza e Sviluppo software

Return to Technical Support ENG

Who is online

Users browsing this forum: No registered users and 1 guest